TELE33324 IT Networking Designing

1. Use the right routers and switches to define the following topology (bandwidth of the interfaces not matter)  
2.  Skip Basic Router Configuration except each router has hostname <your_initial_R#> 5%
3.  Configure the network according to the IP assignment below then apply to the interfaces.  YY is your student ID last two digits.   Save the 1st .pkt file 15%
 
A-End
Z-End
Subnet
R1 G0/0
R2 G0/0
9.yy.9.0/30
R1 G0/1
R3 G0/1
9.yy.9.4/30
R3 G0/0
R4 G0/0
9.yy.9.8/30
R4 G0/1
R2 G0/1
9.yy.9.12/30
R1 G0/2
VLAN20 LAN1SW1
17.yy.0.1/24
R4 G0/2
VLAN30 LAN2SW1
18.yy.0.1/24
LAN1 PC0
VLAN20
17.yy.0.3/24
LAN1 PC1
VLAN20
17.yy.0.4/24
LAN2 PC2
VLAN30
18.yy.0.3/24
LAN2 PC3
VLAN30
18.yy.0.4/24
 
4. Create the layer 2 for all VLANs on the switches and layer 3 on the routers and setup each PC properly.
Save 2nd .pkt file
 
5. You can pick any dynamic interior routing protocol to run on all the routers and allow the advertisement of LAN1 and LAN2 routes everywhere in the network.
Save 3rd .pkt file
 
  Make sure you can ping from any PC to any PC in network layer for the setup.   Why LAN1 PC can ping to LAN2 even they are in different VLAN?   1